Mitsubishi Electric MELSEC iQ-R Series User Manual page 141

Offset/gain setting mode status flag
Normal
■Device number
The following shows the device number of this input signal.
Signal name
Offset/gain setting mode status flag
■In the offset/gain setting mode
When registering the value that has been adjusted with the offset/gain setting, use this flag as an interlock condition to turn on
and off 'User range write request' (YA).
When the offset/gain setting is configured from the offset/gain setting window of an engineering tool, the setting is performed
properly on the window. Therefore, a program is not required to perform the setting.
'Module READY' (X0)
'Offset/gain setting mode
status flag' (XA)
'User range write request' (YA)
Performed by the D/A converter module
Performed by a program
■In the normal output mode
This signal is used as an interlock condition to turn on and off 'User range write request' (YA) when the user range setting is
restored.
For details on restoration of the user range setting, refer to the following.
Page 106 Backing up, Saving, and Restoring Offset/Gain Values
'Module READY' (X0)
'Offset/gain setting mode
status flag' (XA)
'User range write request' (YA)
Performed by the D/A converter module
Performed by a program
CH1
XA
OFF
ON
ON
OFF
ON
ON
CH2
ON
OFF
OFF
ON
OFF
OFF
CH3 CH4
APPX
Appendix 2 I/O Signals
A
139