Section 4: Telephones and Optional Equipment
LED Indications
Setting Up 2PGDAD Module Connections
1.
2.
4-2 ◆ Section 4: Telephones and Optional Equipment
LED
Indication
LED 1
Green LED when
CH1 in use.
LED 2
Green LED when
CH2 in use.
If the 2PGDAD Module is to be wall mounted, it is recommended that all the cable connections
be made first.
In order for the module to ID correctly after setting the jumpers, set the circuit type to "0" for
the module's port in Program 10-03-01 prior to connecting the line cord to the 2PGDAD Module.
Remove the screw from the front of the 2PGDAD module.
Figure 4-2: REMOVE COVER FROM 2PGDAD MODULE
Using a screwdriver, break out the plastic piece covering the cable hole.
Figure 4-3: REMOVE PLASTIC COVER FROM CABLE HOLE
Flashing green LED indicates dipswitch setting
and programming for CH1 is conflicting.
Flashing green LED indicates dipswitch setting
and programming for CH2 is conflicting.
Module
Breakout plastic
for cable access
Note
Aspire S Hardware Manual