NEC Aspire S Manual page 151

For System Alarms:
➻
➻
For System Information Reports:
➻
➻
6. Install the CTU Adapter driver by double-clicking on the SETUP.EXE file.
During the installation of the driver, select the non-procedure mode (by default, the CTI mode is
selected).
http://ws1.necii.com.
7. Attach ferrite beads to the AC-R power cable and USB cables. These should be installed on the
ends of the cables closest to the adapter.
8. Plug the AC-R AC/DC adapter into the AC jack on the side of the adapter and to an AC outlet.
9. Position the adapter with the connector positioned as shown below.
Aspire S Hardware Manual
Section 4: Telephones and Optional Equipment
Program 90-12-01 : System Alarm Output - Output Port Type
Define the output port to be used as the output for system alarm report (0=no setting,
1=NTCPU COM port, 4=CTA/CTU adapter). Set the baud rate for the COM port in Program
10-21-02. The system can have up to 50 reports.
Program 90-12-02 : System Alarm Output - Destination Extension Number
If the output port type (90-12-01) is a CTU, enter the extension number with the CTU connection.
Program 90-13-01 : System Information Output - Output Port Type
Define the output port to be used as the output for system information report (0=no setting,
1=NTCPU COM port, 4=CTA/CTU adapter). Set the baud rate for the COM port in Program
10-21-02. The system can have up to 50 reports.
Program 90-13-02 : System Information Output - Destination Extension Number
If the output port type (90-13-01) is a CTU, enter the extension number with the CTU connection.
For TAPI setup, refer to the Aspire CTI Manual (P/N 0893102) for complete details.
The CTU Adapter driver can be downloaded from the NEC Technical Support web site:
The USB cable is a USB Type B Male (to adapter) to Type A Male Cable (to USB device).
Figure 4-44: WRAPPING THE FERRITE BEADS
You may wish to remove the wall-mount bracket to allow for easier adapter installation
Figure 4-45: POSITIONING THE ADAPTER
Section 4: Telephones and Optional Equipment ◆ 4-45
4