Section 2: PCB Installation and Startup
Analog Station (4SLIDB-S) Daughter Board (Figure 2-9 - Figure 2-10)
The 4SLIDB-S daughter board provides:
●
4 analog extension ports (used for on-
premise analog telephones, fax machines,
and analog modems)
●
Connector for 4SLIU-S PCB
●
Ring Generator
●
Message Wait Lamping Ability
The CN3 connector provides connection to 4
analog station ports and are not polarity sensi-
tive. The 4SLIDB-S is installed on the 4SLIU-S
PCB. Up to 2 PCBs can be installed in the system maximum, but this number may be reduced depending on
how many 4SLIU-S PCBs are installed. If 3 4SLIU-S PCBs are installed, only 1 4SLIDB-S can be installed.
If 4SLIU-S PCBs are installed, the 4SLIDB-S can not be used.
LED Indications
LD1 - LD4
Connector Pin-Outs on 4SLIDB-S
2-22 ◆ Section 2: PCB Installation and Startup
Note: When connecting a fax
machine or analog modem, make sure
to set Program 15-03-03 to '1' (special
terminal) to avoid communication
problems.
LED
Function
Indicates the status of
terminals 5-8.
12345678
Live Status LEDs (on back of PCB)
Figure 2-9: 4SLIDB-S PCB
LED Status
Red On
Red Off
RJ61 Cable Connector - CN3
Pin No.
1
2
3
4
5
6
7
8
LD1 - LD4
CN3
Analog Ports 1-4
CN4
SLIU PCB Earth Ground
Connector
Operation Status
Terminal in use
Terminal idle
Connection
CH4 L1 (tip for port 4)
CH3 L1 (tip for port 3)
CH2 L1 (tip for port 2)
CH1 L2 (ring for port 1)
CH1 L1 (tip for port 1)
CH2 L2 (ring for port 2)
CH3 L2 (ring for port 3)
CH4 L2 (ring for port 4)
Aspire S Hardware Manual