Installing The Voip Pcb - NEC Aspire S Manual

Installing the VoIP PCB:

first, install the VoIP PCB after the other types of extension/trunk PCBs have been installed.
1. Set the run/block switch
Refer to VoIP (VOIPDB-S) Daughter Board (Figure 2-16) (page 2-39) for more details.
2. Install the VOIPU-S PCB into a slot.
3. Set the run/block switch
was found during the self diagnostics routine, the status LED will flash slowly.
4. Connect the VOIPU-S PCB to an external switching hub using an ethernet cable.
5. Tighten the screw on the PCB to secure the card to the cabinet.
6. Refer to the Aspire Software Manual (P/N 0893200) for required programming.
Aspire S Hardware Manual
Section 2: PCB Installation and Startup
To avoid unexpected extension/trunk numbering if the VoIP PCB registers with the system
DOWN
If the VOIPDB-S is to be used, install this prior to inserting the VOIPU-S PCB into the cabinet.
.
UP
Once the system is powered up, with normal operation, the status LED will flash fast. If trouble
CN11
VOIPDB Connector
LED1 PCB Status LED
LED2 DB Run LED
LED3 RIP Session Status LED
LED4 PCMCIA Slot LED
SW2 Reset Switch
Load Jumper
SW1 Load Switch
SW3 Run/Block Switch
JP1 Boot Jumper
CN4 LAN Interface
Connector
LED A [left] and
Act LED B [right]
Figure 2-15: VOIPU-S PCB INSTALLATION
.
CN6
CN14
PCMCIA
CN2
Serial Connector
Section 2: PCB Installation and Startup ◆ 2-37
2