Installing A Lan Device Or Voip Telephone - NEC Aspire S Manual

Installing a LAN Device or VoIP Telephone

Actual installation will vary depending on each customer's installed Aspire S and networking hardware.
1. Plug a cable with an RJ-45 modular jack into the system's VoIP PCB.
2. Connect the RJ-45 modular connector on the opposite end of the cable to the IP telephone or PC's
network interface card (NIC).
When connecting an IP telephone, a connection can then be made to a network PC using the PC
connector on the back of the phone.
3. If local power is to be provided to the IP telephones, connect the AC adapter to the phone.
When using the IPhone (P/N 0890065), set the SW2 dip switch on the bottom of the phone to the
appropriate setting shown below:
4. Plug the AC adapter into an outlet.
Aspire S Hardware Manual
Feeding Method
Local Feeding AC Adapter
Center Feeding NEC Power Patch Panel
(12 port NEC SN1604 PWRMS -
24-port NEC BlueFire 200/24)
Center Feeding Cisco Catalyst Power Patch Panel
Cisco Catalyst PRW Series
Section 6: LAN Connection
Power Source
Section 6: LAN Connection ◆ 6-5
Setting of SW2
1
(48 volts to phone)
2
(data pairs)
6