Testing Telephone Operation - NEC Aspire S Manual

TESTING TELEPHONE OPERATION

The following procedure will help you determine if a problem being experienced is due to the telephone or
the system. Testing the operation of a keyset allows you to check the lamping of each key, the display, and
tones. Follow the procedure below to determine if the phone is operating correctly.
Key Matrix and LED Test
1. Unplug the phone.
2. While holding down dial pad digits 1, 2 and 3, plug the phone back in.
3. Hold down the 1, 2 and 3 digits for approximately 10 seconds then release them.
keys down a few seconds longer.
4. Press any key and its Logical Name should be displayed.
Quitting Test Mode
1. Lift the handset and then replace it.
2. The phone returns to an idle condition.
Aspire S Hardware Manual
Section 3: Installing Extensions and Trunks
If the phone doesn't show "TEST PUSH=" on the display, then repeat Steps 1-3 and hold the
The following chart indicates the Logical Name for each key.
Logical
Keys Name
KEYPAD 0 - 9 D 0 - D 9
KEYPAD * D *
KEYPAD # D #
1 L 1 - L 24
Line Keys 1 - 24
DSS Keys 1 - 10 O 1 - O 10
LND F 1
CONF F 2
HOLD F 3
FLASH F 4
DND F 5
CALL1 F 6
SPK F 7
1
Keys 1, 2 and 3 will also check tones.
2
34-Button Super Display telephone only.
Logical Name Table
Keys
CALL2
MIC
MSG
DIAL
CLEAR
CHECK
SOFT KEY 1-4
2
MENU1
2
MENU2
VOL. UP
VOL. DOWN
Section 3: Installing Extensions and Trunks ◆ 3-17
Logical
Name
F 8
F 9
F 10
F 11
F 12
F 13
S 1 - S 4
011
012
3