Installing An Intramail Compact Flash Card - NEC Aspire S Manual

Installing an IntraMail Compact Flash Card:

1. If not already installed, install the DSPDB daughter board. Included with the DSPDB are four spac-
ers. Install one spacer in each corner of the daughter board. Make sure to attach the spacers from
the back of the daughter board so when installed, the compact flash slot is facing up.
2. Position the daughter board over the CN4 connector on the CPU. Push the board into the connector
on the CPU. Gently push the corners of the daughter board down so the spacers lock into the CPU.
pull the daughter board off.
3. Insert the IntraMail CompactFlash card into the slot in the DSPDB.
Refer to the Aspire IntraMail System Guide, P/N 0893240, for programming details.
Aspire S Hardware Manual
Section 2: PCB Installation and Startup
The system must be powered down prior to installing the IntraMail card.
To remove the daughter board, use pliers to squeeze the top of the spacers together, then gently
CN1
CN4
Figure 2-14: INTRAMAIL INSTALLATION
IntraMail
Spacers
CPU
Section 2: PCB Installation and Startup ◆ 2-33
2