Reverse Buzzer Limit Switch - Pioneer 1200 Maintenance Service Manual

ELECTRICAL COMPONENTS: FE400 ENGINE
Reverse Warning Buzzer Installation
1. Install the screw (3) through the buzzer (2) bracket tab and frame, secure with hardware, and tighten to
14 in-lb (1.6 N·m) (Figure 12-23, Page 12-19). See following NOTE.
NOTE: The reverse warning buzzer is secured at one hole only.
2. Connect the black wire from the wire harness to the negative (–) terminal on the buzzer.
3. Connect the red/white wire from the wire harness to the positive (+) terminal on the buzzer.
4. Reverse removal procedures to install the dash panel on the vehicle. See Key Switch Removal on
page 12-14.
5. Connect the battery cables, positive (+) cable first, and tighten the terminals to 20 ft-lb (27.1 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
BLACK GROUND
RED/WHITE
4
5
6
Figure 12-23 Front Reverse Warning Buzzer

REVERSE BUZZER LIMIT SWITCH

See General Warning, Section 1, Page 1-1.
Testing the Reverse Buzzer Limit Switch
See Test Procedure 19, Section 11, Page 11-40.
Reverse Buzzer Limit Switch Removal
1. Turn the key switch OFF and remove the keyl. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed (Figure 12-1, Page 12-1). See WARNING "To avoid unin-
tentionally starting..." in General Warning, Section 1, Page 1-2.
3. Disconnect the wires from the reverse buzzer limit switch (4) located on the back of the Forward/Reverse
assembly (Figure 12-21, Page 12-18).
4. Remove the nuts (2) and washers (6) from the lockout cam limit switch (5) and slide the lockout cam limit
switch off of the screws. Do not disconnect the wires.
5. Remove the spacers (9) from the reverse buzzer limit switch (4) and slide the reverse buzzer limit switch
off the screws.
2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual
2
3
Reverse Buzzer Limit Switch
Page 12-19
12