Pioneer 1200 Maintenance Service Manual page 262

16
MC012C-AS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK
Unitized Transaxle Installation, Continued:
Figure 16-49 Shock Absorber
25. Connect the 6-gauge white wire to the F2 post and the 6-gauge black ground wire to the A2 post of the
starter generator and tighten to 48 in-lb (5.4 N·m). Connect the 16-gauge yellow wire to the DF post and
tighten to 30 in-lb (3.4 N·m) (Figure 16-51, Page 16-21).
26. Connect the Forward/Reverse shifter and bracket to the transaxle.
26.1. Install the three screws (2) securing the Forward/Reverse shifter cable bracket (1) to transaxle and
tighten to 135 in-lb (15.3 N·m) (Figure 16-36, Page 16-15).
26.2. Place the woodruff key (9) on the shifter shaft.
26.3. Place the shifter lever (6) (aligned with the woodruff key) onto the Forward/Reverse shaft (15).
26.4. Install the nut (3) washer (4) and bolt (7) on the Forward/Reverse shifter lever and tighten to 23 in-
lb (4.1 N·m).
26.5. Position the shifter cable in the shifter cable mounting bracket on the transaxle and tighten the
mounting nuts to 22 ft-lb (29.8 N·m). Connect shifter cable rod end to the shifter arm (Figure 16-52,
Page 16-21).
27. Attach the ground wire to the mounting screw on the oil filler tube mounting bracket and tighten to 50 in-
lb (5.7 N·m) (Figure 16-53, Page 16-21).
28. Connect accelerator cable to actuator cam in the electrical box. Position the accelerator cable in mount-
ing slot in the wall of the electrical box and tighten mounting nuts to 18 in-lb (2.0 N·m) (Figure 16-54,
Page 16-21). Install electrical box cover and tighten cover screw to 18 in-lb (2.0 N·m).
29. Pull fuel line from impulse line fitting of the fuel pump and connect it to the carburetor and secure with a
hose clamp (Figure 16-55, Page 16-21).
Page 16-20 2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual
Unitized Transaxle Installation