Pioneer 1200 Maintenance Service Manual page 259

MC012C-AS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK
BRACKET
Figure 16-41 Accelerator Cable Bracket
10. Hold the arm and shaft in the fully counterclockwise position and tighten the governor arm lever nut to
35 in-lb (4.0 N·m) (Figure 16-43, Page 16-17).
11. Install the key onto the input shaft (Figure 16-44, Page 16-18).
12. Position the driven clutch on the transaxle input shaft and install the washer (yellow side facing out) and
mounting bolt and tighten to 14 ft-lb (19.0 N·m).
13. Install the drive belt. See Drive Belt Installation, Section 17, Page 17-4.
Figure 16-42 Governor Cable Bracket
2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual
Unitized Transaxle Installation
1. Install the governor arm
on the governor shaft.
2. Turn shaft counterclockwise.
3. Pull governor arm rearward.
Figure 16-43 Governor Arm
16
4. Tighten the
retaining nut.
Page 16-17