Mitsubishi Electric R56TB Instruction Manual page 124

15.3.2.5. I/O unit monitor
The XY device variables of I/O unit can be monitored.
The status of input signals are displayed on the upper table, and the status of output signals are displayed on the
lower table.
The signal values can display a 16-bit integer with a mark, or 32-bit integer with a mark by the decimal number or
the hexadecimal number.
The signals to display can set up the continuous range freely with [Monitor setting].
This function can be used with Version R3 or later of CR750-Q/CRnQ-700 robot controllers and Version 3.0 or
later of this software.
This function can be used with all versions of CR800-D/R/Q.
(1) Monitor setting
Tap the [Monitor setting] <a> button. The setting screen of PLC I/O unit monitor is displayed.
Set the starting number of each device and set the number of lines to display. And, set the data size in display
singles and the display method.
After setting, tap the [OK] button.
110
<a>