Table of Contents
Advertisement
PIN
BRACE
\
2 MALE
PlNS
1
OUTER &
INNER
SHIELD
CABLE
CLAMP
/
2 FEMALE
SHIELD
SHIELD
PINS
INSULATOR
CLAMP
2
(MALE),
, 1
(MALE)
3
(FEMALE)
/
'
4
(FEMALE)
REAR VlEW
(CABLE SIDE VIEW)
BARREL
A. STRIP OFF 114 INCHES (6 MMI OF
INSULATION FROM THE TWISTED PAlR AND
2 POWER LEADS.
B. ROUTE THE TWISTED PAlR AND 2
POWER LEADS THROUGH SHIELD CLAMP
AND SHIELD ISOLATOR. KEEP SHIELDS
AWAY FROM EXPOSED TWISTED PAlR AND
POWER LEADS.
C. SOLDER TWISTED PAlR LEADS TO THE
MALE PlNS AND THE POWER LEADS TO THE
FEMALE PINS.
D. INSERT PlNS INTO PIN BRACE, MALE
PlNS ON TOP AND PROTRUDING, FEMALE
PlNS ON THE BOTTOM. ENSURE THAT THE
INSERTED PIN CONFIGURATION CONFORMS
TO REAR VlEW ILLUSTRATION.
CABLE
CLAMP
A. COMB INNER AND OUTER SHIELD
OVER SHIELD CLAMP.
B. INSERT ASSEMBLED CABLE INTO
BARREL.
C. SCREW CABLE CLAMP INTO BARREL.
D. CHECK PlNS TO ASCERTAIN THAT NO
SHORT EXISTS TO THE BARREL OR BETWEEN
PINS.
E. CHECK WIRING PER TABLE
2-
OR
SECTION II OF SYSTEM MANUAL.
PLUG: HP PART NO. 1251-3452
CABLE: HP SPEC CO5-59995A
Figure
E-4.
70780A
Receiver-to-System
Plug
Wiring
(Cont'd)
Advertisement
Table of Contents
Troubleshooting
