Mounting The Metal Covers - Siemens 8DA10 Series Installation And Operating Instructions Manual

Mounting the STG plug
Removing the STG plug
861-9601.9 • INSTALLATION AND OPERATING INSTRUCTIONS • 8DA10 • Revision 11
Connecting the STG plug with the VBSTB4 modular terminal
For 2-, 4- and 10-pole STG plugs make PHOENIX CONTACT, observe the instructions for
installation and removal given hereafter.
The information stated herein refers to the user instructions of PHOENIX CONTACT.
The user is obliged to inform himself about the latest state of the instructions before
installation or removal of the STG plugs, and to observe the manufacturer's instructions.
➭ Manufacturer's site: https://www.phoenixcontact.com
➭ Hold the STG plug horizontally over the plug shaft of the VBSTB4 modular terminal.
➭ Push the STG plug horizontally into the modular terminal until the STG plug latches in.
✔ The STG plug is latched into the modular terminal and mounted.
➭ Push the STG plug slightly to the screwing side until the latching noses come out of
the latching slots of the modular terminal.
➭ Pull the STG plug horizontally out of the VBSTB4 modular terminal.
✔ The STG plug is removed.
29.3

Mounting the metal covers

➭ Screw all metal covers to the frames again.
INFORMATION
Installation
135/214