Siemens 8DA10 Series Installation And Operating Instructions Manual page 55

861-9601.9 • INSTALLATION AND OPERATING INSTRUCTIONS • 8DA10 • Revision 11
The transport holes for pushing the lifting rods in are marked on the transport unit with
a red symbol.
Fig. 33: Position of transport holes
➭ If necessary, remove the switchgear termination.
➭ Push the lifting rods into the transport holes at the front and at the rear.
➭ Attach ropes or chains at the ends of the lifting rods.
➭ Stretch the ropes or chains by lifting the hoisting tackle carefully.
➭ If the ropes or chains are touching the transport unit, use transport tackle/expander.
➭ Lift the transport unit carefully.
➭ Lif the transport unit by means of a crane.
Fig. 35: Example for craning the transport unit
① 1037 mm (height of switchgear dependent on built-on components)
②
462 mm
Fig. 34: Marking of transport holes
Installation
55/214