Checking The Accessories; Schutzgeräte Prüfen; Correcting Circuit Diagrams; Instructing The Operating Personnel - Siemens 8DA10 Series Installation And Operating Instructions Manual

861-9601.9 • INSTALLATION AND OPERATING INSTRUCTIONS • 8DA10 • Revision 11
33.3

Checking the accessories

As standard, the switchgear accessories comprise:
• Operating levers
• Keys to operate the switching devices
• Single-line diagrams
• Operating instructions
• Warning signs
• Customer-specific supplies
➭ Make the switchgear accessories available in the switchgear room or in a neighboring room
clearly and ready to hand.
➭ Check the accessories in the service flap (option).
33.4 Checking protection devices
➭ Check the version of the firmware installed on the protection devices, and update
if required, see page 9, "IT security".
33.5

Correcting circuit diagrams

➭ Note any modifications which may have been made during installation or commissioning in
the supplied circuit diagrams.
➭ After completion of the installation work, ask the regional Siemens representative for
correction of the original circuit diagrams.
33.6

Instructing the operating personnel

➭ Hand over the operating instructions to the operating personnel before commissioning.
➭ Make the operating personnel familiar with all technical details and operation of the
switchgear before switchgear acceptance.
Installation
149/214