Toshiba Q9 Plus Bypass ASD Installation & Operation Manual page 207

6.5.3 Output of set frequency speed reach signal
f101 : Speed reach setting frequency
f102 : Speed reach detection band
 Function
When the output frequency becomes equal to the frequency set by f101f102, an ON or OFF
signal is generated.
[Parameter setting]
Parameter setting of frequency and detection band
Title
Speed reach setting frequency
f101
Speed reach detection band
f102
Parameter setting of output terminal selection
Title
Output terminal
f131
selection 2A (OUT)
Setting value 9 is reverse signal.
Note: Set f132 to assign to FLA-FLC-FLB terminals and f130 to RY-RC terminal.
If the detection band value + the set frequency is less than the designated frequency
Set frequency attainment signal
: OUT-NO terminals
Function
Function Adjustment range
0-255
(Refer to section 11.7.)
Output frequency [Hz]
 + 

 - 
0
Inversion of set frequency
attainment signal
F-27
Adjustment range
0.0-fh (Hz)
0.0-fh (Hz)
Setting
8: RCHF (Set frequency attainment
signal)
Time [s]
ON
OFF
ON
OFF
E6581611
Default setting
0.0
2.5
6