Toshiba Q9 Plus Bypass ASD Installation & Operation Manual page 329

 List of logic input terminal function settings
Parameter
programmed value
Positive Negative
logic logic
    No function
    Forward run command
Reverse run command
   
    Standby
    Reset command
Preset-speed command 1
   
Preset-speed command 2
   
    Preset-speed command 3
    Preset-speed command 4
    Jog run mode
Emergency stop by external signal
   
    DC braking command
2nd acceleration/deceleration
   
3rd acceleration/deceleration
   
    2nd V/F control mode switching
2nd stall prevention level
   
PID control prohibition
   
External thermal error input
   
Forced local from communication
   
    Operation hold (hold of 3-wire operation)
    PID integral/differential clear
PID characteristics switching
   
Forced run operation
   
    Fire speed operation
    Acceleration/deceleration suspend signal
Power failure synchronized signal
   
Factory specific coefficient *1
   
    Factory specific coefficient *1
*1: Factory specific coefficients are manufacturer setting menus. Do not change the value of these parameters.
*2: Active when  (frequency setting mode selection) =  (UP/DOWN from external logic input) is set.
The frequency setup range is from  to  (maximum frequency). The acceleration/deceleration time
relative to the set frequency is / while the acceleration/deceleration speed is not switched.
☆ Refer to section 11.6 for details about the input terminal function.
Parameter
programmed value
Function
Positive
logic
 
 
 
 
 
 
 
 
 
 













 to 




G-5
Function
Negative
logic
Integrating wattmeter (kWh) display
 
clear
  Trace back trigger signal
  Light-load high-speed operation
prohibitive signal
  Holding of RY-RC terminal output
  Holding of OUT-NO terminal output
Frequency UP *2
 
Frequency DOWN *2
 
  Clear frequency UP/DOWN *2
  Coast stop command
  Forward/reverse selection
Run/Stop command

Frequency reference command forced

switching
Frequency setting mode terminal block

Command mode terminal block

 Parameter editing permission
Fast stop command 1

Fast stop command 2

Traverse permission signal

Low voltage operation

 Forward deceleration
 Forward stop
Reverse deceleration

Reverse stop

Factory specific coefficient *1
 No.2 motor switching
Parameter editing prohibition

Parameter reading prohibition


E6581611
7