Toshiba Q9 Plus Bypass ASD Installation & Operation Manual page 214

Setting of switching terminals
To switch to motor 2, assign the following functions to a terminal not being used. It is also possible to switch
to acceleration/deceleration 2 (AD2). Refer to section 6.15.1 for details.
It is possible to set 3 functions for terminal F and R, and 2 functions for terminal S1 and RES.
Input terminal function number
24
AD2 AD3
OFF OFF
ON OFF
OFF
OFF OFF
6
OFF OFF
- OFF
Note 1: Each of the following numbers (25, 27, 29, 33, 153) are reverse signals.
Note 2: pt and "V/F constant" cannot be switched while running. Stop the motor before switching.
Note 3: If motor is switched, the setting to retain and subtract an integral value of motor electronic thermal is possible.
Example of setting a terminal for switching: Sink logic
26 28 32
VF2 OCS2
OFF OFF
OFF OFF
ON OFF OFF
ON OFF
OFF ON
- -
vl and f170, vlv and f171, vb and f172 can be switched while running.
Refer to section 5.6 for details.
F (F: Forward run)
CC
S1(AD2)
S2(VF2)
S3(OCS2)
Parameters changed from applicable parameters and
152
default standards
MOT2
Default setting :
OFF
acc fs00、dec
OFF
acc fs10、dec
OFF
During stop : pt
vlv f171, vb
OFF
During run : vl
vb f172
f601 f185
OFF
→, →, → , →,
→( is fixed when =or),
ON
→,→, →,
→
Forward run command
2nd acceleration/deceleration switch
2nd V/F setting switch
2nd stall prevention operation switch
F-34
pt, vl, vlv, vb,
thr, acc, dec,
fs02, f601
f501、f502
f511、f502
V/F constant , vl f170,
f172, thr f173
f170, vlv f171,
E6581611
fs03
fs12