Hitachi PRIMAIDE 1440 Instruction Manual page 118

<Utility setting screen>
UTILITY (OFFSET=1, TIME CONSTANT=2,
4 USE PROG=3, PMT VOLT=4, OTHERS=5)
Press numeric key 4 and then the ENT key.
(v) The pmt voltage setting screen appears.
<Pmt voltage setting screen>
PMT VOLTAGE (SUPER HIGH=1, HIGH=2, MID=3,
3 LOW=4, SUPER LOW=5)
Press numeric key 3 and then the ENT key.
(vi) The 1
(vii) Press
reappears.
<Utility setting screen>
UTILITY (OFFSET=1, TIME CONSTANT=2,
5 USE PROG=3, PMT VOLT=4, OTHERS=5)
Press numeric key 5 and then the ENT key.
(viii) The others setting screen appears.
<Others setting screen>
OTHERS (Em BANDWIDTH=1, ERROR OUT=2,
1 LEAK SENSOR=3, LAMP=4)
Press numeric key 1 and then the ENT key.
(ix) The Em bandwidth setting screen appears.
<Em bandwidth setting screen>
Em BANDWIDTH (STANDARD=1, WIDE=2)
1
Press numeric key 1 or 2 and then the ENT key.
*1: STANDARD = emission spectrum bandwidth 15 nm
2: WIDE = emission spectrum bandwidth 30 nm
4 - 5
st
monitor screen reappears.
SET UP
UTLTY
key, and the utility setting screen