Table of Contents
Advertisement
3.3 Installation
3.3.1 Installation Direction and Spacing
Each unit is installed in a sealed structure electric cabinet as a principle. Observe the following points
when installing into the electric cabinet.
(1) Install each unit vertically, so that it is visible from the front.
(2) Consider the heat radiation and wiring of each unit. Refer to the following drawing, and secure
space for ventilation.
(3) Install the personal computer main unit paying particular attention to the specification conditions of
the selected personal computer.
Base I/O unit
Relay card
D CI N
H A ND LE
EMG2
CF 61
EMG1
RS 23 2C
E NC #2
10mm or more
(Note) The relay card can be added on to the base I/O unit. Refer to "6.6 Installation to the Base I/O
Unit" for the installation method when adding on.
CAUTION
Always observe the direction of installation.
3. Installation
3.3 Installation
0
0
E N C1
SKIP
SV 2
CF 10
SV 1
C R3 1
CF 31 CF 32
CF 33
CF 34
RI02
D CI N
RI01
10mm
or more
150mm or more
(heat radiation and
wiring space)
Top
100mm or more
(heat radiation space)
Remote I/O unit
Servo drive unit
MI TSUB ISHI
10mm
or more
10mm or more
15mm or more
(wiring space)
Bottom
8
Spindle drive unit
MI TSUB ISHI
30mm or more
10mm
or more
15mm or more
(wiring space)
Advertisement
Table of Contents
