Pci Nc Card Mounting Procedure - Mitsubishi Electric MELDASMAGIC64 Connection Manual

4.5.2 PCI NC Card Mounting Procedure

Install the software and mount the NC Card following the Setup Instruction Manual (BNP-B2191).
The software will not be installed correctly if the software installation and NC Card mounting procedure
are mistaken.
Mount the NC Card onto the personal computer with the following procedures.
(1) Set the rotary switch CDNO and slide switch SW1.
(Note) Before touching the NC Card, touch an exposed metal section of the personal computer to
discharge any static electricity.
Pay attention not to touch the NC Card, personal computer chip or circuit.
Location of PCI NC Card (FCU6-HR655) switches
Roles of each switch
CDNO (rotary switch): Use to set the PCI NC Card's station No.
SW1 (slide switch): Use to set the PCI NC Card's power supply (internal/external).
CDNO setting
Switch Card
0 1st card
1 2nd card
2 3rd card
3 4th card
4 5th card
5 6th card
6 7th card
7 8th card
8 9th card
9 10th card
A 11th card
B 12th card
C 13th card
D 14th card
E 15th card
F 16th card
The default setting is "0".
4. NC Card (HR621/HR623/FCU6-HR655) Connection
4.5 PCI NC Card Mounting
CDNO
SW1
SW1 setting
Switch Supply method
L Internal supply
M External supply
The default setting is "L".
Connect a stabilized power supply to the CF62 and CF63 connectors
when using an external power supply.
CF62
B A T
B A T
CF63
Details
+5V/+12V is supplied by
PCI bus.
+5V/+12V is supplied by
stabilized power supply.
B A T
B A T
L
M
SW1
CF63
28
AC FAIL
CF62
+12V/+5V
Stabilized
power supply