Panasonic BM-ET200 Operating Instructions Manual page 18

G Connector Terminal
Pin No. Port Name
q-1 RECOGNITION RESULT
OUTPUT 1
ACCEPT
q-2 RECOGNITION RESULT
OUTPUT 1 GND
ACCEPT
q-3
RECOGNITION START
TRIGGER INTPUT
q-4 RECOGNITION START
TRIGGER INTPUT GND
G Interface Board Connector
Pin No. Port Name
w-1 POWER
(card reader)
w-2 GND
(card reader)
w-3
DATA 0/RS-485 (B)
(card reader)
w-4 DATA 1/RS-485 (A)
(card reader)
18
Label marking I/O
RLT1 OUT
GND
TRG IN
GND
Label
Interface
marking
PWR Wiegand OUT
/ RS-485 Not used
−
GND Wiegand
/ RS-485 Not used
DAT0 Wiegand OUT
B RS-485(B) IN/OUT
DAT1 Wiegand OUT
A RS-485(A) IN/OUT
Signal Description
Recognition result output 1
This terminal is activated
when recognition is success-
fully completed.
An alarm signal is input to
this terminal to start recogni-
tion.
I/O Signal Description
Supplies power to a card
reader.
−
This is the ground termi-
nal for the power supply
and communication
between the iris reader
and a card reader.
−
A signal (DATA0) is input
from a card reader to this
terminal.
A signal (RS-485 (B)) is
input from or output to a
card reader.
To the RS-485A
terminal of
RWK400
A signal (DATA0) is input
from a card reader to this
terminal.
A signal (RS-485 (A)) is
input from or output to a
card reader.
To the RS-485B
terminal of
RWK400
Remarks
24 V DC, 100 mA (Max)
Make contact output
Normally Open contact
Active low, Pulse width: 0.1 s
to 60 s
0 V to 5 V DC, 24 mA (Max),
Active low,
Pulse width: 200 ms or more
Remarks
5 V DC, 100 mA (Max)
Note: Do not connect a
card reader if the rat-
ing is different.
−
GND
−
0 V to 5 V DC, 25 mA
(Max), Active low
Differential input: ± 0.2 V
or more
Differential output: ± 2 V
or more
(A)
(When termination is ON)
(B)
0 V to 5 V DC, 25 mA
(Max), Active low
Differential input: ± 0.2 V
or more
Differential output: ± 2 V
or more
(A)
(When termination is ON)
(B)