Panasonic BM-ET200 Operating Instructions Manual page 30

Important:
• Connect the cable firmly. Otherwise, that may
cause loose connection or cable disconnection.
• Do not mistake signal terminals and GND terminals.
12. Connect the earth to the GND terminal by using the
earth ground cable (supplied).
Secure the GND cables of iris reader and interface
board together.
GND cable of interface board
GND
Interface board
Caution: Earth ground cable (supplied) must be con-
nected to the earth ground.
13. If necessary, connect the option camera (not supplied)
to the iris reader with the BNC cable (supplied to the
option camera).
Important: Connect the LAN cable and audio output
cable before connecting the option camera to the
iris reader. Otherwise, the option camera may hide
the connectors, and connections may be hard.
(1) Fix the option camera to the iris reader with the
option camera screw supplied to the camera.
Option camera
screw (Supplied to
the option camera)
Option camera
30
Earth ground cable
Earth
Hook the upper holes of option camera on
these protrusions.
Option camera screw holes
(2) Insert the option camera firmly into the CN6 con-
nector until the connector clicks.
CN6 connector
(3) Insert the video output cable supplied to the option
camera firmly into the CN7 connector, and connect
the video output cable of the option camera to the
the video input cable connected to an external
device (for example, a digital disk recorder).
CN7 connector
Video output cable
(Supplied to the option camera)
14. Remove the sheet from the back side of front cover.
15. Attach the front cover to the main unit.
Fit the screw hole and protrusions of front cover in the
main unit, and fix the front cover fixing screw with the
tamperproof screw driver tool (supplied).
Important: Check the settings of setup switches before
attaching the front cover. (Refer to p. 21.)
Screw hole