Panasonic BM-ET200 Operating Instructions Manual page 29

6. Connect the LAN cable and audio output cable to the
iris reader.
Attach the ferrite core supplied to the LAN cable and
audio output cable.
Audio output connector
Ferrite core
7. Fix the power cable to the iris reader with the supplied
clamping tool and clamping screw.
(Cut off the extra portion of clamping tool.)
Clamping tool
8. Connect the DC 12 V or DC 24 V power cable to the iris
reader.
Important:
• Do not mistake + and –. The wrong cable connec-
tion may cause trouble.
• Do not connect an AC power-supply device. The
iris reader works 12 V DC/24 V DC only.
• Refer to p. 84 for details on recommended external
power-supply device.
• Do not supply the power to the iris reader until all
other connections are completed.
LAN connector
Clamping tool screw
(3 mm tapping screw,
supplied)
Power terminal
9. Connect the cable for the recognition result output and
trigger input terminals to the connector terminal.
Important:
• Connect the cable firmly. Otherwise, that may
cause loose connection or cable disconnection.
• Do not mistake signal terminals and GND terminals.
10. Connect the interface board to the iris reader.
Important: Wiegand and RS-485 interfaces are avail-
able in the network mode only. In the stand-alone
mode, these interfaces are unavailable.
(1) Insert the interface board into the connector firmly
until the connector clicks.
(2) Fix the interface board to the iris reader with the
interface board screw.
(3) Select the communication interface for card reader
and access control panel by performing the RS-
485/Wiegand switch setting of the interface board.
Refer to p. 22 for setting. Refer to Step 12 for how to
secure the GND cable of interface board.
GND cable
Interface board
11. If necessary, connect the cable for the alarm terminals,
cable for the Wiegand terminals, and cable for the RS-
485 terminals to the connector terminal. (Refer to p. 23
for connection example.)
Interface board
Connector terminal
Interface board screw
29