Panasonic BM-ET200 Operating Instructions Manual page 21

G Setup Switches of Iris Reader
Pin No. Factory default
1 OFF
2 OFF
3 OFF
4 OFF
5 OFF
6 OFF
7 OFF
8 OFF
G Setup Switches of Interface Board SW1
Setting name
Start-up Resets the software to
the factory default.
Operation Selects the operation
mode.
Not used Set this switch to OFF
any time.
IP address mode IP address can be set
to the fixed value
regardless of the cur-
rent setting. Set this
switch to ON when the
IP address that has
been set is forgotten.
Ethernet auto- Ethernet setting
negotiation
Ethernet 100 M/ Ethernet setting
10 M
Ethernet Full/Half Ethernet setting
Tamper detection Cancels the tamper
cancel detection. Set this
switch to ON when the
front cover is removed
for servicing.
For access control panel
SW1 SW2
ON ON
1 2 3 4 1
SW1 SW2
ON ON
1 2 3 4 1
SW1 SW2
ON ON
1 2 3 4 1
Function ON
Factory
default soft-
ware
Stand-alone
mode
−
Static IP
address is
assigned.
Fixed
10 M
Half
Cancel
For card reader
SW1
ON
2 3 4 1 2 3 4
SW1
ON
2 3 4 1 2 3 4
SW1
ON
2 3 4 1 2 3 4
OFF Remarks
−
Operation
software
−
Network
mode
− −
IP address Static IP address:
set by an 192.168.0.3
administrator
Auto-negotia- _
tion
100 M Available only
when 5 is ON
Full Available only
when 5 is ON
Detect After servicing, set
this switch to OFF.
If the front cover is
attached with this
switch ON, buzzer
sound is activat-
ed.
SW2
ON
1 2 3 4
SW2
ON
1 2 3 4
SW2
ON
1 2 3 4
21