Panasonic BM-ET200 Operating Instructions Manual page 19

Pin No. Port Name
w-5 ACCEPT-LED
(access control
panel)
w-6 REJECT-LED
(access control
panel)
w-7 POWER
(access control
panel)
w-8 GND
(access control
panel)
w-9 DATA 0/RS-485 (B)
(access control
panel)
w-10
DATA 1/RS-485 (A)
(access control
panel)
w-11 ALARM OUTPUT 2
TAMPER DETEC-
TION
w -12 ALARM OUTPUT 2
TAMPER DETEC-
TION GND
Label
Interface
marking
ACPT Wiegand IN
/ RS-485 Not used
RJCT Wiegand IN
/ RS-485 Not used
PWR Wiegand IN
/ RS-485 Not used
−
GND Wiegand
/ RS-485 Not used
DAT0 Wiegand IN
B RS-485 IN/OUT
(B)
DAT1 Wiegand IN
A RS-485(A) IN/OUT
−
ALM2 OUT
−
GND
I/O Signal Description
A signal (Wiegand
ACCEPT-LED) is input to
control the ACCEPT indi-
cator of this iris reader
when Wiegand output is
set up.
−
A signal (Wiegand
REJECT-LED) is input to
control the
REJECT indicator of this
iris reader when Wiegand
output is set up.
−
The iris reader works even
when nothing is connect-
ed to this terminal.
−
The iris reader works even
when nothing is connect-
ed to this terminal.
−
A signal (DATA0) is out-
put from this terminal to
an access control panel.
A signal (RS-485 (B)) is
input from or output to an
access control panel.
A signal (DATA1) is out-
put from this terminal to
an access control panel.
A signal (RS-485 (A)) is
input from or output to an
access control panel
This terminal is activated
when the iris reader
enters the "tamper detec-
tion" mode by the tamper
detection switch at the
front or rear panel (acti-
vated until the "tamper
detection" mode is can-
celed).
Remarks
0 V to 5 V DC, 24 mA
(Max), Active low, Pulse
width: 200 ms or more
−
0 V to 5 V DC, 24 mA
(Max), Active low, Pulse
width: 200 ms or more
−
5 V DC
−
GND
−
0 V to 5 V DC, 25 mA
(Max), Active low
Differential input: ± 0.2 V
or more
Differential output: ± 2 V
or more
(A)
(When termination is ON)
(B)
0 V to 5 V DC, 25 mA
(Max), Active low
Differential input: ± 0.2 V
or more
Differential output: ± 2 V
or more
(A) (When termination is ON)
(B)
24 V DC, 24 mA (Max)
Open collector output
Normally Open contact
Active low
19