Installation And Connections - Panasonic BM-ET200 Operating Instructions Manual

Installation and Connections

Cautions:
• Attach this iris reader to a flat wall. After the installation,
secure the iris reader to prevent dropping.
• This system must be installed within the protected
premise in accordance with the National Electrical
Code(NFPA70), and local authorities having jurisdiction.
• All interconnecting devices must be UL listed.
• Alarm output2 (tamper detection) must be connected to
UL Listed Access Control Panels to disable operation
during tamper alarm.
Iris sever
Switching hub* 3
GND cable
(Mandatory)
Earth
Tamper detection
alarm light, etc.
Alarm input
Iris reader
4 3 2 1 4 3 2 1
ON ON
LAN cable
ON ON
1 2 3 4 1 2 3 4
1
Relay*
Relay* 1
Signal GND
Recorder
Master clock
Notes:
• These operating instructions only describe how to
install the iris reader to the wall. This iris reader will not
operate properly if you do not complete the setup.
Refer to p. 28.
• The UL Listed card reader when employed must be
suitable for use with the selected UL Listed Access
Control Panels. Refer to the UL Listed Access Control
Panels Installation Instructions for compatibility with the
UL Listed card readers and compatibility with the BM-
ET200.
• The use of an external recorder and master clock has
not been evaluated by UL.
* 1 Attach a relay if necessary.
Do not use relay out to control door directly.
Only UL Listed Access Control Panels should be connected
to the door.
* 2 These devices are independent to BM-ET200.
* 3 This iris camera supports auto-negotiation.
When a switching hub supporting auto-sensing are used,
auto-detect may not activate properly, and the connection
may not be established.
Card reader: Wiegand setting
Access control panel: Wiegand setting
Power terminal
12 V DC
or
24 V DC
Card reader* 2
Wiegand DATA1 → w–10
Wiegand DATA0 → w–9
→ w–8
Wiegand GND
Access control panel*
Wiegand DATA1 → w–4
Wiegand DATA0 → w–3
Wiegand GND → w–2
Wiegand power → w–1
q–1
q–2
q–3
q–4
+
–
2
Electric lock*
2
23