Panasonic BM-ET200 Operating Instructions Manual page 35

No.
Use a LAN cable to connect the setup PC and reader(s), and attach the front cover.
3
Lead the LAN cable out of the rear side or the cable hole of the bottom side. (Refer to p. 29.)
Supply the power to the iris reader.
4
Perform the following settings using the web browser on the PC.
5
• Register administrators. (Refer to p. 36.)
• Set up the users with the operator's privilege. (Refer to p. 37.)
• Set up the operation information and recognition method. (Refer to p. 40.)
Turn off the power supply.
6
Detach the front cover, and remove the LAN cable.
7
Attach the front cover to the iris reader.
8
Connect the numeric key to the iris reader, and supply the power to the iris reader.
Register users with the numeric key.
• Shift from the recognition mode to the administrator mode. (Refer to p. 53.)
9
• Register users. (Refer to p. 54.)
• Shift from the administrator mode to the recognition mode. (Refer to p. 53.)
Procedure
35