I Configure The Settings Relating To System [Reader Setting] - Panasonic BM-ET200 Operating Instructions Manual

I Configure the Settings Relating to System [Reader Setting]

The basic settings, recognition method settings, and the network settings can be configured on this page.
The "Reader Setting" page has 3 tabs of the [Operation Info.] tab, the [Recognition Method] tab and the [Network] tab.
Configure the Settings Relating to Iris Reader Operation [Operation Info.]
Click the [Operation Info.] tab on the "Reader Setting" page.
(Refer to pages 37 and 38.)
Configure the basic settings relating to iris reader operation on this page.
[Audio Mode]
Select the iris reader audio mode.
Mute: There is no audio output.
Simple: An audio output of "Identification completed" or
"Sorry you were not identified" is generated based on
the result of recognition.
Full: There are a voice guidance giving instructions such
as "Please move a little closer" etc. as well as recogni-
tion results.
[Guidance Language]
Select the language of voice guidance from the following.
Selects the guidance language of the iris reader.
You can select one of the following: "English", "Japanese",
"German", "French", "Italian", "Spanish", "Russian", "Chinese",
"Korean", "Arabic", "Portuguese", "Turkish", "Dutch", and
"Swedish".
Default: Japanese
[Output 1 (Recognized Signal)]
[Output]
Decides whether or not to send out a pulse signal from the
Output 1 (Recognized Signal) terminal at successful recog-
nition.
Either "Yes" or "No" is selected for setting.
Default: No
[Output Width]
Setup becomes possible when "Yes" is selected with
[Output 1 (Recognized Signal)]. The selected output width
after multiplied by 100 ms as a pulse signal is sent out from
the "Output 1 (Recognized Signal)" terminal at successful
recognition.
Available value: 1 to 600
40
[Output 2 (Rejected Signal)]
[Output]
Decides whether or not to send out a pulse signal from the
Output 2 (Rejected Signal) terminal at unsuccessful recog-
nition.
Either "Yes" or "No" is selected for setting.
Default: No
[Output Width]
Setup becomes possible when "Yes" is selected with
[Output 2 (Rejected Signal)]. The selected output width
after multiplied by 100 ms as a pulse signal is sent out from
the "Output 2 (Rejected Signal)" terminal at successful
recognition.
Available value: 1 to 600
[Live Indicator]
Selects the stat "Off", "Blinking", or "On".
Off: Live indicator is always off during operation.
Blinking: Live indicator blinks during operation.
On: Live indicator is always on during operation.
Default: Blinking
[External Trigger Input]
When "Yes" is selected, operation of recognition is started
with an input from the outside.
Default: No
[Buzzer]
When "Yes" is selected, it is possible to cause the buzzer to
sound with an external input.
sounding, it is impossible to carry out recognition.
Default: No
While the buzzer keeps