Table of Contents
Advertisement
SAFETY INSTRUCTIONS (Continued)
⚫ When you install the cover of the equipment, do not put your fingers inside
the cover. If you do, your fingers may get caught and injured.
⚫ If you bend the tab of the grounding spring at the slot by mistake when you
remove an extension board, be careful not to cut your fingers when you fix the
bend because the tab has a sharp edge.
⚫ When you install or remove an HDD／SSD, make sure you do not cut your
fingers on the protrusions.
⚫ When you install or remove a DVD drive, make sure you do not cut your
fingers on the protrusions.
⚫ Rack-mounting metal fittings are designed to be used for pulling out the
equipment toward the front by hooking your fingers on the handles. Do not
grip the handles to lift up or carry the equipment. If you do, the equipment
may fall and personal injury may result.
⚫ Thoroughly check if the rack-mounting metal fittings are attached properly.
If they are not attached properly or the screws are loose, the equipment may
fall and personal injury may result.
⚫ When you install the equipment on the mounting metal fitting for vertical
installation, do not use set screws for the cover to secure the equipment. If
you use the set screws for the cover, the equipment may fall and personal
injury may result.
S-9
(Page 6-7)
(Page 6-10)
(Page 6-15)
(Page 6-18)
(Page 6-20)
(Page 6-23)
Advertisement
Table of Contents
