Table of Contents
Advertisement
(3) Removing a Drive bay 3 HDD／SSD (Option)
[1] Open the front cover referring to [1] of "(2) Removing an HDD／SSD".
[2] Loosen two set screws for the Drive case.
[3] Hold two set screws for the Drive case and pull out the case.
Set screws for the Drive case
(4) Installing an HDD／SSD
Follow the procedure described in "(2) Removing an HDD／SSD" or "(3) Removing a
Drive bay 3 HDD／SSD (Option)" in reverse to install an HDD／SSD.
< NOTE >
・When you pull out an HDD／SSD, make sure you do not apply too much force
to the connector. Slowly pull out the hard disk in order not to subject the HDD／
SSD.
・When you connect an HDD／SSD to a connector, do not subject the HDD／
SSD to shock or jarring.
・Always install the system disk in drive bay 1. Even if the system disk is
incorrectly installed in the drive bay 2, the OS will start up, so pay attention to
the mounting position of the disk.
・The HDD1 and HDD2 of the B model must have the same capacity. The SSD1
and SSD2 of the T model must also have the same capacity. Do not install
HDDs or SSDs with different capacities.
・The drive bay 3 is a dedicated HDD／SSD bay. Do not install other devices.
・After having closed front cover, please confirm that you are locked. Front cover
may open by a shock.
Figure 6-7 Removing a Drive bay 3 HDD／SSD
6-17
6. CHECKUP AND MAINTENANCE
Advertisement
Table of Contents
