Table of Contents
Advertisement
SAFETY INSTRUCTIONS (Continued)
⚫ Put the HDD／SSD on a shock-absorbing material such as an antistatic
cushion even for a temporary task. If you put an HDD directly on a hard
surface such as a desktop, a failure or a shorter life span of the unit or loss of
data may result due to possible jarring or shock.
⚫ Never remove the screws on an HDD／SSD while the power to the unit is
on. Never hot-swap HDDs／SSDs. If you do either of these, failure of the
equipment or the drive may result.
⚫ Before you replace an HDD／SSD, make sure you shut down the OS, unplug the
power cord from the outlet, and wait for at least one minute.
⚫ For the B model (SATA HDD software RAID1 hot swap model) and the
T model (SATA SSD software RAID1 hot swap model), when you need to
replace a failed HDD or SSD in RAID1 while the power is on, see "10.4.2
Recovery from a failure in one drive".
⚫ Install or remove an HDD／SSD only if necessary, for example, when you need to
replace an HDD／SSD due to failure. If you do it frequently, failure of the
equipment may result.
⚫ Fully insert an HDD／SSD. Loose contact and missing screws may result in
failure.
⚫ Do not give a shock to an installing HDD／SSD and the already mounted
HDD／SSD during installing. If you give a shock to an HDD／SSD, failure
of the drive may result.
⚫ Be careful when assembling the SSD into drive bay 3,please insert and
remove it straight. If you do not insert and remove it straight, it may not fit
properly.
⚫ Make sure you do not apply too much force to the connector of the DVD
drive and the top of the DVD drive. If you do so, failure of the DVD drive
may result.
⚫ The orientation of a rack-mounting metal fitting is fixed if it is to be attached
to the equipment. Make sure the orientation is correct.
S-15
(Page 6-15)
(Page 6-18)
(Page 6-20)
Advertisement
Table of Contents
