Chapter 2 Useful Features
14. On the configuration menu of each logical port, put a cursor onto iSCSI Offload Protocol and select
Enabled.
Press <ESC> key to return to NIC Partition Configuration menu.
Make sure that the port you have configured is changed to "Eth : iSCSI".
If you want to configure any other logical port, repeat steps 12 and 13.
15. Press <ESC> key to return to Device List menu.
If you configure any other device, repeat steps 8 through 14.
Press <ESC> key to return to Exit Configuration menu, and select Exit and Save Configurations.
16. Press any key to exit Configuration Menu.
In NPAR mode, up to two protocols can be set to Enabled per a port.
Tip
Express5800/B120f-h Maintenance Guide
10. Advanced LAN Configuration
149