NEC Express5800 Series Maintenance Manual page 159

Chapter 3 Appendix
Error Message
A014 Memory Error detected in
CPU2_DIMM8
A015 Memory Error detected in
CPU2_DIMM9
A420 Online Spare Memory was not
ready.
A421 Mirroring Memory was not
ready.
A423 Lockstep was not ready.
A428 Cluster On Die was not
ready.
A429 DIMM population is
insufficient for Cluster On
Die.
A800 Memory not detected
A804 Latest memory module is
corrupted.
AE01 CPU1_DIMM1 has been disabled. A memory error was detected.
AE02 CPU1_DIMM2 has been disabled. A memory error was detected.
AE03 CPU1_DIMM3 has been disabled. A memory error was detected.
AE04 CPU1_DIMM4 has been disabled. A memory error was detected.
AE05 CPU1_DIMM5 has been disabled. A memory error was detected.
AE06 CPU1_DIMM6 has been disabled. A memory error was detected.
AE06 CPU1_DIMM6 has been disabled. A memory error was detected.
AE07 CPU1_DIMM7 has been disabled. A memory error was detected.
AE08 CPU1_DIMM8 has been disabled. A memory error was detected.
AE09 CPU1_DIMM9 has been disabled. A memory error was detected.
Cause
An error was detected on
CPU2_DIMM8.
An error was detected on
CPU2_DIMM9.
Failed to enable the Sparing feature
by the current memory
configuration.
Failed to enable the Mirroring
feature by the current memory
configuration.
Failed to enable the LockStep
feature by the current memory
configuration.
Cluster On Die feature is
disabled in this hardware
configuration.
Cluster On Die feature cannot work
with this memory configuration.
No available memory is installed.
The BIOS flash memory was failed.
CPU1_DIMM1 has been disabled.
CPU1_DIMM2 has been disabled.
CPU1_DIMM3 has been disabled.
CPU1_DIMM4 has been disabled.
CPU1_DIMM5 has been disabled.
CPU1_DIMM6 has been disabled.
CPU1_DIMM6 has been disabled.
CPU1_DIMM7 has been disabled.
CPU1_DIMM8 has been disabled.
CPU1_DIMM9 has been disabled.
Express5800/B120f-h Maintenance Guide
1. Error Message of POST and Virtual LCD
Solution
Contact your sales representative.
Start SETUP, and confirm the settings of
Memory RAS Mode. When Memory
Sparing, Memory Mirroring, or Memory
LockStep feature is enabled, POST
detects this error if DIMMs are degraded.
Start SETUP, and specify Yes for
Memory Retest, then execute Save
Changes and Exit.
Replace the processor with the one that
supports this feature. Or, run SETUP and
select Disabled for the Cluster On Die.
Check if memory configuration is correct.
Check if DIMMs are properly installed..
Contact your sales representative.
159