Installation - Hitachi PC-ARF Technical Catalogue

4 Individual remote controls
Receiver kit for wireless remote control

4.5.2.2 Installation


Components list
Unpack the unit and check that:
• The package contains all the components (see next table).
• All components are in perfect condition.
Otherwise, contact the manufacturer.
Receiver kit PC-ALHC
Connection cable
Flexible cable tie
Wiring cover
Installation and operation
manual

Installation procedure
C A U T I O N
Follow these installation procedures carefully. Failure to do so may cause the receiver to become detached from the panel causing a
serious accident.
1 Install the wireless receiver kit, indoor unit and air panel at the same time.
2 If installing the wireless receiver kit after the indoor unit, unplug the power source from the indoor unit. Then remove
the grille from the air inlet.
3 This receiver kit can only be installed in one position.
4 Remove the cover from the electrical box of the indoor
unit and connect the cable to the terminal block (white),
as shown below.
192
TCGB0106 rev.0 - 12/2014
Name
Connection cable
Quant. Comments
1 With connection wire
1
2 For securing the cables
1 To protect the connection cable
1 Installation and operation unit instructions
Installation position
Cable hole
Electrical box
Cable tie trade "A"
–
Terminal board
Electrical box of the indoor unit
PCB
Cable tie trade "B"