Installation Procedure - Hitachi PC-ARF Technical Catalogue

Hide thumbs Also See for PC-ARF:

Table of Contents

9 Control accessories

Wall and stand mounted support for CSNET Manager LT/XT

9.1.3 Installation procedure

Wall mounted support

C A U T I O N

This device cannot built in neither installed without providing ventilation to the aluminium sink behind

Place the support on a resistant wall.

CSNET Manager can be wall mounted by using any standard VESA 75 mm wall mounted support for LT & XT and VESA

100 mm for XT only. HITACHI offers the following wall mounted accessory, model code 7E512300.

Stand mounted support

C A U T I O N

This device cannot built in neither installed without providing ventilation to the aluminium sink behind.

CSNET Manager can be stand mounted by using any standard VESA 75 mm stand mounted support for LT & XT and

VESA 100 mm for XT only. HITACHI offers the following stand mounted accessory VESA 75, model code 7E512301.

The stand comes disassembled in 2 parts:

1 Place the fixing screen support 90 degrees with respect to its arm.

2 Put the screen upside down and insert the 4 stand screws on the rear of the screen (the power source connector will

be at the bottom of the screen). There are 8 holes on the support, 4 for the LT screen and the other 4 for the XT screen.

C A U T I O N

In order to avoid damage to the screen, protect it before setting it upside down.

TCGB0106 rev.0 - 12/2014

(To be informed later)

Fixing screen