Csnet Web (Psc-A160Web1); Safety Summary - Hitachi PC-ARF Technical Catalogue

6 Building air conditioning controls

CSNET WEB (PSC-A160WEB1)

6.1 CSNET WEB (PSC-A160WEB1)

6.1.1 Safety summary

HITACHI cannot anticipate every possible circumstance that might involve a potential hazard.
D A N G E R
• DO NOT pour water into the remote controller. This product is equipped with electrical parts. If poured, it will
cause a serious electrical shock.
• DO NOT perform installation work and electrical wiring connection by yourself. Contact your HITACHI distribu-
tor or dealer and ask them for installation work and electrical wiring by service person.
• Do not connect the electrical power to the control system until the preparation for the trial operation has been
finalized successfully.
C A U T I O N
• DO NOT install the PSC-A160WEB1 in places as:
- Where there is oil vapour and the oil is dispersed.
- Where the hot springs are near (in a sulphuric environment).
- Where generation, flowing, staying or leaking of flammable gas is detected.
Where the sea is near (in the salty environment).
-
- An acid or alkaline environment.
• DO NOT install the indoor unit, outdoor unit, controller and cable within approximately 3 meters from strong electro magnetic wave
radiators such as medical equipment. In case that the controller is installed in a place where there is electromagnetic wave radiation,
shield the controller and cables by covering with the steel box and running the cable through the metal conduit tube.
• In case that there is electric noise at the power source for the indoor unit, provide a noise filter.
• Use specified cables to connect between indoor unit and remote control switch. Selecting incorrect cables may lead to fire or electrical
shock.
• Use a power circuit which is not subject to surges in demand.
N O T E
• The installer and system specialist shall comply with local regulations or standards for the safety. The following standards may be ap-
plicable, if local regulations are not available. International Organization for Standardization, ISO5149 or European Standard, EN378
or Japan Standard, KHKS0010.
• Perform electrical work according to the Installation Manual. As for the electrical wiring work and check, turn OFF the main power
supply before opening/closing the service cover of indoor unit. If service cover is opened with main power supply left on, it may result
in an electrical shock.
• It is assumed that this control remote will be operated and serviced by English speaking people. If this is not the case, the customer
should add safety such as and operating signs in the native language for non English speakers.
• This manual should be considered as a permanent part of the air conditioning equipment and should remain with the air conditioning
equipment.
• This appliance must be used only by adult and capable people, having received the technical information or instructions to handle this
appliance properly and safely.
• Children should be supervised to ensure that they do not play with the appliance.
• Important: read and understand this manual before using this remote controller.
If you have any questions, contact your HITACHI distributor or dealer.
411 411
TCGB0106 rev.0 - 12/2014
6