Adding Bridge Multicast Address Members - Dell PowerConnect 3424 User Manual

Enabling Bridge Multicast Filtering on the device
1
Open the Global Parameters page.
2
Select Enable in the Bridge Multicast Filtering field.
3
Click Apply Changes.
Bridge Multicast Filtering is enabled on the device.
Enabling IGMP Snooping on the device
1
Open the Global Parameters page.
2
Select Enable in the IGMP Snooping Status field.
3
Click Apply Changes.
IGMP Snooping is enabled on the device.
Enabling Multicast Filtering and IGMP Snooping Using CLI Commands
The following table summarizes the equivalent CLI commands for enabling Multicast Filtering
and IGMP Snooping as displayed on the Global Parameters page.
Table 7-89. Multicast Filtering and Snooping CLI Commands
CLI Command
bridge multicast filtering
ip igmp snooping
The following is an example of the CLI commands:
console(config)# bridge multicast filtering
console(config)# ip igmp snooping

Adding Bridge Multicast Address Members

The Bridge Multicast Group page displays the ports and LAGs attached to the Multicast service
group in the Ports and LAGs tables. The Port and LAG tables also reflect the manner in which the
port or LAGs joined the Multicast group. Ports can be added either to existing groups or to new
326
Configuring Switch Information
Description
Enables filtering of Multicast addresses.
Enables Internet Group Membership Protocol
(IGMP) snooping.