Dell PowerConnect 3424 User Manual page 378

The Interface Settings page contains the following fields:
Interface — The specific port or LAG to configure.
Disable "Trust" Mode on Interface — Disables Trust mode on the specified interface. This setting
overrides the Trust mode configured on the device globally.
Set Default CoS For Incoming Traffic To — Sets the default CoS tag value for untagged packets.
The CoS tag values are 0-7. The default value is 0.
Assigning QoS settings for an interface:
1
Open the Interface Settings page.
2
Select an interface in the Interface field.
3
Define the fields.
4
Click Apply Changes.
The CoS settings are assigned to the interface.
Displaying QoS/CoS settings:
1
Open the Interface Settings page.
2
Click Show All.
The Interface Table is displayed.
Assigning QoS Interfaces Using the CLI Commands
The following table summarizes the equivalent CLI commands for configuring fields in the
Interface Settings page.
Table 9-110. QoS Interface CLI Commands
CLI Command
qos trust
no qos trust
The following is an example of the CLI commands:
console(config)# interface ethernet 1/e15
console(config-if)# qos trust
378
Configuring Quality of Service
Description
Enables the trust mode.
Disables Trust state on each port.