Ether Vlan Untag - Fujitsu XG Series User Manual

XG Series User's Guide

5.1.1.10 ether vlan untag

Function
Available Model
Syntax
Options
Use Mode
Explanation
Caution
Default
Set the untagged VLAN.
XG0224 / XG0448 / XG2600
ether <number> vlan untag <untagged_vidlist>
<number>
• ether port number
Set a port number to use with a decimal value.
When setting multiple port numbers, separate them with commas (,).
When setting sequential numbers, separate them with hyphens (-). (Example: "1-8")
<untagged_vidlist>
• Untagged VLAN ID list
Set an untagged VLAN ID.
When setting multiple IDs, separate them with commas (,).
Configuration mode (admin class)
Set an untagged VLAN ID.
• To add a VLAN, specify the VLAN ID list including already registered VLANs.
• Although multiple vid numbers can be specified in the "untagged_vidlist", the following
conditions must be satisfied.
- Only a single port can be defined as a port VLAN.
If multiple VLANs with no protocol VLAN settings have been specified, only the VLAN
with the smallest number will be enabled.
- The protocol VLANs of up to 11 protocols (system definition protocol (ipv4/ipv6/fna)
or user definition (up to 8 definitions)) can be defined.
The M1 port internally uses maximum VLAN ID in unused.
Therefore, the communication of the M1 port is temporarily interrupted when VLAN ID
allocated in the M1 port is specified by the vlan untag command, and the TCP session is
cut. (Only XG2600)
On occasions when "ether vlan tag" command is not defined:
It is assumed that 1 has been specified as the default VLAN ID.
ether <number> vlan untag 1
On occasions when "ether vlan tag"
It is assumed that "ether vlan untag" command has not been specified.
command is defined:
101
Chapter 5 Command Reference
Port Information Settings