Table of Contents
Advertisement
XG Series User's Guide
19)
System Capabilities information
Value which is sent with System Capabilities TLV
info=
: Available function
enabled= : Enabled function
Bridge
: Bridge functon
Router
: Router function
When system-description is disabled by lldp info command, this value is not
displayed.
20)
Management address information
Value which is sent with Management Address TLV
When SNMP agent address is set, IPv4 address and MAC address are
displayed.
When management-address is disabled by lldp info command, this value is not
displayed.
21)
Port VLAN ID information
Value which is sen with ID TLV
When port-vlan-id is disabled by lldp info command, this value is not displayed.
22)
Protocol information
Value which is sent with ocol VLAN ID TLV
When port-and-protocol-vlan-id is disabled by lldp info command, this value is
not displayed.
23)
VLAN name information
Value which is sent with IEEE802.1 VLAN Name TLV
When vlan-name is disabled by lldp info command, this value is not displayed.
24)
Protocol ID information
Value which is sent with IEEE802.1 Protocol Identity TLV
This value is not displayed.
25)
MAC/PHY Configuration/Status information
Value which is sent with IEEE802.3 MAC/PHY Configuration/Status TLV.
When mac-phy-configuration-status is disabled by lldp info command, this value
is not displayed.
26)
Power via MDI information
Value which is sent with IEEE802.3 Power Via MDI TLV
support=
PSE
PD
not supported
supported
disabled
enabled
When power-via-mdi is disabled by lldp info command,
this value is not displayed.
27)
Linkaggregation information
Value which is sent with linkaggregation TLV
When link-aggregation is disabled by lldp info command, this value is not
displayed.
: Function Information
: Power supply function
: Power demand function
: No function
: Supported
: Disable function
: Enable function
484
LLDP Counter, Log, Statistics, and Status Display and Clear Operation
Chapter 5 Command Reference
Commands
Advertisement
Table of Contents
