Table of Contents
Advertisement
XG Series User's Guide
1)
Port number
2)
Indicates that the information display at the right side is for this device (Actor) or
the remote device (Partner).
3)
Indicates that the LACP mode is active or passive.
The passive is displayed if the valid LACP remote system information has not
been obtained.
4)
Indicates the LACP state as follows.
T (LACP_Timeout):
The LACPDU's receive timeout has been set to Short Timeout (3
seconds).
If not shown, the Long Timeout (90 seconds) has been set.
A (Aggregation):
The links can be aggregated. If not shown, they are separate links.
S (Synchronization):
The link has been synchronized with the aggregator.
C (Collecting):
A frame is ready to receive.
D (Distributing):
A frame is ready to send.
d (defaulted):
The default parameters have been applied to the LACP remote system
(Partner) information being held by this device.
E (Expired):
The receiver of LACP remote system has expired.
5)
Indicates the link aggregation ID.
All 0's indicates that the valid LACP remote system information has not been
obtained.
(a) (b)
8000,00-0b-5d-89-02-ba,0002 8000,2
a) System priority
b) System ID (MAC address)
c) Aggregation key
d) Port priority
e) Port number
6)
A value at left shows the port priority, and a value at right shows the port number.
These values are equivalent to port priority (d) and port number (e) of Item (5).
(c) (d) (e)
420
LACP Counter, Log, Statistics, and Status Display and Clear Operation
Chapter 5 Command Reference
Commands
Advertisement
Table of Contents
