Table of Contents
Advertisement
XG Series User's Guide
Default
Note 3.
This command is unavailable if the allowable upper limit for the device is exceeded.
The allowable upper limits are as follows.
• Upper limit based on "commands"
128 commands for the entire device.
Up to 128 commands can be set for the entire device, including the
"lan ip6
filter"commands.
The priority for each command is as follows.
1)
"vlan ip6filter"
command
A smaller VLAN ID has a higher priority among VLANs.
2)
"lan ip6 filter"
command
A smaller lan definition number has a higher priority among lans.
If up to 128 of
"vlan ip6filter"
filter"
command will be no longer applied.
• Upper limit based on rule
128 rules for the entire device.
For the
"vlan ip6filter"
and
varies depending on the contents of the specified acl as shown below.
The number of rules for each ACL is as follows.
- For ACL to set TCP or UDP
Result of multiplication between the number of source ports and the number of
destination ports for TCP or UDP
- For ACL to set ICMP
Result of multiplication between the number of ICMP TYPEs and the number of
ICMP CODEs for ICMP
- For ACL not to set TCP, UDP, or ICMP
1
You can expand the upper limit to use
resource distribution.
Note 4.
Up to 700 commands can be set for the entire device, including the definitions which refer
to ACL such as
"ether
macfilter",
"vlan qos
aclmap",
"vlan ip6qos
ip6 dscp"
and "serverinfo filter" commands.
It is assumed that the IPv6 filter is not set.
commands have been defined, the subsequent
"lan ip6 filter"
commands, the number of rules to be used
"resource filter distribution"
"ether qos
aclmap",
aclmap",
"lan ip
filter",
202
Chapter 5 Command Reference
"vlan ip6filter"
"lan ip6
command and change
"vlan
macfilter",
"vlan
ip6filter",
"lan ip
dscp",
"lan ip6
filter",
LAN Information Settings
and
"lan
Advertisement
Table of Contents
