Ether Output Rate Control Information; Ether Ratecontrol - Fujitsu XG Series User Manual

XG Series User's Guide
5.1.10

ether output rate control information

This section explains about the commands related to ether output rate control information.

5.1.10.1 ether ratecontrol

Function
Available Model
Syntax
Options
Use Mode
Explanation
Caution
Default
Set output rate limit of ether port
XG2600
ether <number> ratecontrol <rate>
<number>
• ether port number
Set a port number to use with a decimal value.
When setting multiple port numbers, separate them with commas (,).
When setting sequential numbers, separate them with hyphens (-). (Example: "1-8")
<rate>
• Output rate
Specify output rate which is limited in the ether port with Mbps or Gbps
40m to 10000m
1g to 10g
If "10000m" or "10g" is set, packets are not limited.
Configuration mode (admin class)
Set output rate control.
"ether qos mode drr" command and
same time and same port.
It is assumed that the output rate limit function is not used.
"ether ratecontrol"
151
Chapter 5 Command Reference
command can not use at the
Port Information Settings