Fujitsu XG Series User Manual page 487

XG Series User's Guide
Execution Example
# show lldp neighbors
Port Neighbor Counts
---- ---------------
(1) (2)
1 1
2 0
#
# show lldp neighbors port 1-2 detail
[PORT 1]
Neighbor Counts : 1
Neighbor 1
Chassis ID
Port ID
Time To Live(TTL)
Port Description
System Name
System Description
ST 2008'"
System Capabilities
Management Address
Management Address
IEEE802.1
Port VLAN ID
Port And Protocol VLAN ID
VLAN Name
IEEE802.3
MAC/PHY Configuration/Status
Power Via MDI
Link Aggregation
Maximum Frame Size
[PORT 2]
Neighbor Counts : 0
#
1) Physical port number
Ether port number
2) Number of neighbor devices
Number of neighbor devices information which is received
3) Neighbor ID
Neighbor ID
4) Chassis ID
Value which is received with Chassis ID TLV
subtype= : subtype value (4 is MAC address)
info= : representative MAC address
5) Port ID information
Value which is recived with Port ID TLV
6) LLDP TTL information (s) information
Value which is received with Time To Live (TTL) TLV
: subtype=4(MAC) info=02:00:0e:d1:47:80
: subtype=5(ifName) info="MB/0"
: 120 seconds
: info="EthernetPort(MB/line0)"
: info=""
: info="'Si-R180B' '128.0 V34.00' 'Wed Feb 13 13:11:14 J
: info=Router
enabled=Router
: address subtype=1(IPv4) info=192.168.1.181
interface number subtype=2(ifIndex) info=10000
oid=""
: address subtype=6(MAC) info=02:00:0e:d1:47:80
interface number subtype=2(ifIndex) info=1
oid=""
: PVID=0
: flags=not supported,disabled
PPVID=0
: VID=30
name="lan9"
: support/status=supported,enabled
capability=1(10BASE-T half duplex mode),
type=16(100BASE-TX full duplex mode)
: support=PSE,not supported
: status=not capable
: size=1500
487
LLDP Counter, Log, Statistics, and Status Display and Clear Operation
Chapter 5 Command Reference
---(1)
---(2)
---(3)
---(4)
---(5)
---(6)
---(7)
---(8)
---(10)
---(11)
---(12)
---(13)
---(14)
---(16)
2(10BASE-T full duplex mode),
4(100BASE-TX half duplex mode),
5(100BASE-TX full duplex mode)
---(17)
---(18)
---(19)
Commands