Table of Contents
Advertisement
Chapter 2: Installing the Voice Mail
Increasing the Number of Voice Mail Ports
To install analog port card(s) to increase the number of Voice Mail ports:
1.
If this is a new system, skip this step and go to step 2. If you have an existing VANGARD
Mail System, you must shut down the Voice Mail before you install any cards:
From the Main Menu, select SD.
Press Y at the prompt asking if you are sure you want to shut down the system.
If you have a software version lower than 9.08, wait 20 seconds before disconnecting
power. Otherwise, you may corrupt the Voice Mail database.
Disconnect the external power supply to turn off system power.
2.
Use a screwdriver to loosen the six screws that secure the cover to the cabinet, as shown
below.
Figure 3: Removing the Cabinet Cover
3.
Remove the cabinet cover.
Installing the Voice Mail Hardware
VANGARD Mail/i-Series Quick Setup Guide
9
Advertisement
Table of Contents
