Table of Contents
Advertisement
Testing the Voice Mail Operation
Testing the Voice Mail
Chapter 4: Voice Mail Programming
Once VANGARD Mail has been installed and initialized, you should perform the following two
tests to check Voice Mail operation.
Test 1 (for the Automated Attendant):
1.
Call into a trunk that you have assigned to VANGARD Mail.
2.
Listen for: Thank you for calling. If you are calling from a Touch Tone phone, please dial
the extension number you wish to reach or dial 0 for assistance. If you are calling from a
rotary dial phone, please stay on the line for assistance.
Test 2 (for Voice Mail):
1.
From the MAIN MENU -> prompt, select DI - Diagnostics and then press Enter.
Enter the password (the default password is CTL), if requested and press Enter.
2.
Select PA - Port Activity and then press Enter.
3.
4.
At a Multibutton extension, press the Message Key.
5.
Listen for: You have —messages (if you did not install a default Security Code) or Please
enter your security code.
6.
Repeat steps 4 and 5 until you see each Voice Mail port operating.
If you do not hear the stated voice prompts, check the equipment connections and the telephone
system programming for Voice Mail.
Testing the Voice Mail Operation
VANGARD Mail/i-Series Quick Setup Guide
37
Advertisement
Table of Contents
