Installing Digital Port Cards - NEC VANGARD i-Series Quick Setup Manual

Installing the Voice Mail Hardware
Increasing the Number of Voice Mail Ports

Installing Digital Port Cards

Availability:
12 VANGARD Mail/i-Series Quick Setup Guide
8. Push down on the port card's hole to seat the card firmly in the cabinet, as shown in the fol-
lowing illustration.
Figure 6: Seating the Card Firmly in the Cabinet
9. Secure the card with two screws. Do not over-tighten these screws.
10. Repeat steps 4 through 9 for each card that you are installing.
11. Replace the cabinet cover.
12. Tighten the screws loosened in step 2 to secure the cover.
13. If this is a new system, go to "Placing the Voice Mail in the Proper Location" on page 17. If
this is not a new installation, go to "Installing a Ferrite Bead on Each Line Cord" on page 22.
VANGARD Mail with software version 10.06 or higher. Also requires
VANGARD Mail Cabinet P/N 17770A.
Each digital port card (P/N 17774ADIG) has 2 connectors and provides 4 ports. Each connector on
a port card provides 2 Voice Mail ports. See Figure 7.
Your digital VANGARD Mail System supports up to 8 ports.
If you have a 4-Port digital VANGARD Mail System, you can expand it with 4 additional ports.
Voice
Board
For cabinet 17770,
J11 and J1
should mate.
For cabinet 17770A,
J7 and J1
should mate.
Align holes
Chapter 2: Installing the Voice Mail