Table of Contents
Advertisement
Installing the Voice Mail Hardware
Increasing the Number of Voice Mail Ports
16
VANGARD Mail/i-Series Quick Setup Guide
7.
Push down on the port card's hole to seat the card firmly in the cabinet, as shown in the fol-
lowing illustration.
Figure 12: Seating the Card Firmly in the Cabinet
8.
Secure the card with two screws. Do not over-tighten these screws.
9.
Repeat steps 4 through 9 for each card that you are installing.
10. Replace the cabinet cover.
11. Tighten the screws loosened in step 2 to secure the cover.
12. If this is a new system, go to "Placing the Voice Mail in the Proper Location" on page 17. If
this is not a new installation, go to "Installing a Ferrite Bead on Each Line Cord" on page 22.
Voice
Board
CN1
J7
and
should mate
Chapter 2: Installing the Voice Mail
Align holes
Advertisement
Table of Contents
